Guide relay module

Clamp pull: 100KGF.CM

Contact resistance: ≤50MQ

Installation method: clip guide installation

Rated parameters: 8A250VAC (two open and two closed)

12A 250VAC (open and closed)

Wiring form: straight plug-in card jaw wiring, use 0.5~1MM wire

Product material: high precision phosphorus copper C5191 surface coated tin PA6+GF20 (ROHS)

Insertion and withdrawal force: the first insertion force is>30N, ≤40N; the first withdrawal force is>20N, <35N

Electrical strength: 3500VAC, 50HZ, 1MIN between adjacent terminals (leakage current 1MA)

Load protection

Each circuit works independently, with a high-power output coated with tin and an input positive or negative control

Self-replicating insurance

Block instantaneous current, protect the circuit, and return to normal after power failure and fault removal

No need for manual replacement

The rectifier bridge makes it easier to connect the positive and negative terminals without distinguishing between them

The surge protection absorbs the excess residual voltage current to protect the line safety

PNP NPN Dual use

The wiring is convenient and quick

Plug-in wiring is tool-free, efficient and time-saving. Both soft and hard wires can be used

Plug-out design

It has the function of pulling and fixing to prevent relay from falling off in a vibrating environment and is easy to replace

Guide installation

Standard industrial guide rail installation can be installed on NS35 7.5 or NS32 guide groove. It is easy and quick to install and firmly stable